I have a cisco827 and a 3005 concentrator. I have been trying to use the web based CRWS config tool on the router. When I click on "easyvpn" and fill out the first page I then go to the second page and get prompted for "username, password and domain". I have two blocks in which to enter the data but I am not sure what to enter or how to enter it. I am using nt domain authentication so I am assuming that I put in my domain account and password, if this is correct where do I put in the domain name? and how do I put it in? after the password using some special character I am thinking but at this time I am really needing some help. For what it is worth, I then go into the console port of the router and it is constanlty screaming for a username, password, and domain, again how do I enter it?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...