need help configuring bellsouth dsl with my cisco 1700 router
I am new with Cisco, but I want to learn.Can anybody help me with configuring dsl with my 1700 router? I try to call bellsouth , but the only support bellsouth routers.I know with westell modem you need to set with ppoe, but does 1700 have ppoe or just PPP? An explanation would greatly be appreciated. What is the difference with PPPoe and PPP. How do I setup. What WAN protocol do i use and how to configure NAT.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...