Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need help configuring static nat on 2600 IOS 11.3(2)XA1

I'm attempting to setup static NAT to help ease the process of consolidating addresses. I have followed the guidelines to the word as presented in the Cisco documentation series for my IOS, but it seems the commands simply do not exist.

I am referring to this document:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/dial_r/drprt11/drnat.htm#40606

I am executing the commands in Global config mode:

pericles(config)#ip nat inside source ?

list Specify access list describing local addresses

pericles(config)#ip nat inside source static ?

% Unrecognized command

Is there something I am missing? I have tried adding the inside and outside designations to the interfaces first, then trying to specify the static translations, but the command still does not appear. Seems like all I can do is configure dynamic translations, which is not what I am trying to do.

Here's what I get when I query the ip nat command:

pericles(config)#ip nat ?

inside Inside address translation

translation NAT translation entry configuration

seems odd that there aren't more commands, like pool or outside.

What am I missing here? Any help would be very appreciated.

2 REPLIES
New Member

Re: Need help configuring static nat on 2600 IOS 11.3(2)XA1

I had the same problem and found that 11.3 doesn't support NAT . I suggest you upgrade your code in order to support NAT ...

cheers,

Dave

New Member

Re: Need help configuring static nat on 2600 IOS 11.3(2)XA1

I don't think that "full" NAT is supported in the IP release of 11.3. I believe that you need "IP Plus".

Mick.

99
Views
0
Helpful
2
Replies