04-05-2006 03:34 AM - edited 03-03-2019 02:40 AM
HI Guys
Need u r help in migration from layer2 switched network to layer3.
here is the setup there are 9 sites connected with a 10gig backbone in a ring.each site has a 6513 but at the data centre site we having two 6513.we are having a combination of voice and data vlans.at present all the sites are connected with layer2 trunks.all the trunks are teminated at the core ie datacentre site.so how should i procedd and what are the advantages of it ie migration.
Thanks
Mahmood
04-05-2006 03:38 AM
For this migration you first need to assign IP addresses to your connections between switches. This could be /30 (or /31, if supported) subnets. You should also consider running some dynamic routing protocol such as OSPF between switches.
Hope this helps.
04-05-2006 03:59 AM
Hi
Thanks for replying.yeh we are planning to run OSPF.as u said that we need to have ip address configured on the swithces so that means that we need to have a MSFC at each site am i right.
Thanks
Mahmood
04-07-2006 02:11 AM
Yes, you will need routing capabilities at each site.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: