cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
346
Views
0
Helpful
3
Replies

Need help on Cisco 7513

azinding
Level 1
Level 1

We have cisco 7513 with 2*RSP4(64 DRAM 16 FLASH), VIP2-15(1 FastEthernet, 8 port Serial EIA/TIA-232), VIP2-40(1 FastEthernet, 8 port Serial V.35)

IOS rsp-jsv-mz.112-7.P

When I change (update) IOS from ver.11.2(7)P to ver.12.1(6) or 12.0(3)T VIP2-15 not initialized.

in than can be reason?

3 Replies 3

Erick Bergquist
Level 6
Level 6

Hi,

I ran the above through the HW/SW matrix and it looks like 12.1(6) should be ok, but 12.0(3)T isn't okay. The matching 12.0T image for the hardware you listed is 12.0(7)T at a minimum. 12.2(1) or higher mainline release is also ok according to the matrix.

What errors are you getting on boot? Maybe if you post a capture we can be of more help.

Regards, Erick

I have similar config on my 7513, and ran the HW/SW matrix for the first time, after i saw your note. I found 12.0(7)T at a minimum, Does it mean that I can use 12.0(19) IOS. I like to use 12.0(19) because its a "GD". Thanks. vic.

ottok
Level 1
Level 1

I would suggest using 12.0(19)S.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco