So, two things.... First, are you saying you can ping 22.214.171.124 from the core router, but nothing attached to gig0/3? Second, you don't have any network statement covering the primary address of this interface in your ospf router configuration--did you intend to advertise the network attached to gig0/3 into ospf?
I would try adding a network statement that covers the primary address of gig0/3. If you can ping the interface address, but not anything beyond the interface, then I would try using an extended ping to ping something attached to gig0/3 using 192.168.254.17 as the source address, and see if that works. If it doesn't, the problem is most likely a default gateway on the device, rather than something with the router.
I am replacing the current edge with this new cisco.
From core I ping 126.96.36.199 and get replies. I leave ping runing. I swap the eth cables from old edge to new edge. Ping stop then come back replying. TTL is now 255 from 32. Tells em that it is indeed working. Now I plug in one of my many t1 interfaces into say Serial3/2 and then the pings stop. I can no longer ping any ip on GigEth3.
Does that make any sense? It's like as long as I
do not plug any interfaces live into the new edge1 that the routes work. Soon as I do plug one into it and link state changes to UP the routes stop working.
But I can still from console of Edge1 reach the internet. Just cannot reach any interface other than GigE1 and 2.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.