I'm trying to make this lab work, using 2 x 2611 routers, the dialing router calls and and the modem picks up at the other end, but the called router does not respond to the chap challenge, I'm able to dialing using hyper terminal for exec dialing, that's working fine...
I have turned on debug for chat, ppp authentication and ppp negotiation on both routers, but I only get an output on the calling router.
Here is the output from the calling router:
00:07:51: CHAT65: Attempting async line dialer script
00:07:51: CHAT65: Dialing using Modem script: async & System script: none
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
The debug on the calling router makes it look like things are looped, since the Magic Number, the packet IDs, and the name used by the CHAP process are all the same (indicating we are receiving the packet that we just sent out).
There isn't really much in the config that could cause this (and the config looks fine anyway), so I would suggest you confirm the numbers being dialed and the modem configs. Debug modem might be of interest to you, too. Finally, you could try to reverse telnet from one of the routers to the aux port, manually dial 905889xxxx, and see if you get the login prompt for the remote.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...