Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need LOTS of help with RAS - it's me again, HELP!!

CISCO2650

S26C-12205

ACS-2600-GENERIC

MEM2600-8FS

WIC-BLANK-PANEL

NM-BLANK-PANEL

MEM2650-32D

MEM2650-16D=

MEM2600-8U16FS=

NM-16AM=

MMTL-3600/2600-16=

WIC-1DSU-T1=

CAB-AC=

I was wondering if this is the correct configuration to support

1) analog (inbound only) modem calls

2) BRI (inbound only)

3) no external modems required

4) analog dialtone from a PBX for inbound calls

Roland...

1 REPLY
Cisco Employee

Re: Need LOTS of help with RAS - it's me again, HELP!!

To support analog calls(over the POTS line) in the router NM-16AM is fine but to support isdn calls dialied in using BRI line, WIC-1DSU-T1 will not be the right hardware.

WIC-1DSU-T1 dosen't do channelized T1 or ISDN. Pl. visit here for more informtaion

http://www.cisco.com/warp/public/cc/pd/rt/1600/prodlit/t1dsu_ds.htm

So you need to have one or more BRI interfaces on the router to terminate the isdn calls on it..Hardware for that will be WIC-1B-U.

94
Views
0
Helpful
1
Replies
CreatePlease to create content