Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need some help in configuration

Hi!

First of all I am a newbie in the Cisco field. I am trying to cofigure a Cisco 1720 Router. I am using a cable which in one end has a RJ45 connector(connected to the console) and the other end is DB9 (connected to my W2K PC COM2 port). I start a Hyperterminal session (9600bits/sec,8,None,1,None) but all I get is the cursor flashing and nothing else. Is there something wrong with what I try to do? Any suggestion would be greatly appreciated as this thing is wasting me a lot of time.

Thank you

2 REPLIES
Gold

Re: Need some help in configuration

1. try com1. do you get a connected message at the bottom of hyperterm?

are you running anything like hotsync for palm ?

are you using the rj-45 that came with the router ?

New Member

Re: Need some help in configuration

Try port com1. And also check RJ-45 cable is proper. try establishing connection from the connect prompt again.

83
Views
0
Helpful
2
Replies