Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Need to connect TTY lines across WAN

Hello,

How do I connect 2 tty lines across a WAN ?

The scenario is that a Paging Switch connects to a Cisco 3660 on TTY line 97. This Switch needs to talk to another Paging Switch connected to a similar Cisco 3660 on line 166. It's like a Master/Slave config. The end modules on the Paging switch have no IP routing capability.

Any info on how to proceed is appreciated.

Thx

George

1 REPLY
Cisco Employee

Re: Need to connect TTY lines across WAN

You need to tunnel async data over ip. For that you can use "autocommand telnet " feature under the line config of 3660.

Following link will explain that in details about the config etc..

http://www.cisco.com/warp/public/700/14.shtml

103
Views
3
Helpful
1
Replies
CreatePlease to create content