Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

need to span a 6509

I have a 6509 running native IOS and I can not figure out what the syntax is to span a port on it. Set based switches are no problem to span but we can't figure it out on this native IOS box, we have a sniffer set up and just need to know what the syntax is to configure the port to mirror. Any help would be appreciated

1 REPLY
New Member

Re: need to span a 6509

example of the two commands you'll need:

monitor session 1 source interface Fa3/10

monitor session 1 destination interface Fa6/1

there are plenty of options to go for in addition but this will get you off and running!

135
Views
0
Helpful
1
Replies
CreatePlease to create content