i am going to put 6509E with sup720 as my MDF and 6509E with sup32- 10GE as an IDF. now i would like to do a 10G connectivity Between MDF and IDF but before that i have a queation in my mind
if i need 1G connectivity to the Desktop how many ports are allowed in IDF to get good result and if we don't want oversubscribe on 10G uplink between IDF and MDF. is there any ratio like if we have a 10 G then ------- much port of 1G are allowed to get a good result.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...