i seen on cisco that we have a almost 4 to5 different type of power for 6500s.i have a 110V in my office and i want to use MDf and IDF both 6500 with 10G connectivity between them. IDF are almost full of ports. i seen that there is 2 power supply 4000w on 220V that is not possible for me. and second is 6000W with 220V and of we out 110V it gives you 2900W. this power is ok for me but i want to know if i orderd this power then is good for fully loded 6509E with sup32 or is not enough? we must do 220V power or not?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.