I recently upgraded my 2611 routers to 12.3(5) and configured AutoQoS. All worked well for about 1 week then several sites started getting intermittant failures of the router(s) to forward NetBIOS info, for instance nbtstat -a for a distant device will fail until the router is reloaded. I'm not sure where to look to figure out what's happening. Any one have any suggestions?
You could probably check the IP connectivity. You could try some debug commands to find what is happening to the NetBIOS packets. But, before that you can check if this is a known isuse with the hardware or software version that you are using, if you have access to Bug toolkit..
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...