Netconf equivalent for "show running-config" in IOS XR

[alexleonov]

Hello,

I have an ASR9K router, on which I want to get full running configurration in XML format.

To start netconf prompt, I go with

netconf echo format

And then I send the following request:

<?xml version="1.0" encoding="UTF-8"?>
<rpc message-id="106" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
  <get-config>
       <source>
         <running/>
       </source>
       <filter>
           <Configuration/>
       </filter>
   </get-config>
</rpc>  
]]>]]>

In the output, it is seen that it is trimmed after start of ISIS configuration. In addition, there is an error message:

<error-message xml:lang="en">
            &apos;XMLMDA&apos; detected the &apos;warning&apos; condition &apos;An XML request provided too little or too much values for a class&apos;
        </error-message>
        <error-info>
            <Configuration ErrorCode="0x4368a200" ErrorMsg="&apos;XMLMDA&apos; detected the &apos;warning&apos; condition &apos;An XML request provided too little or too much values for a class&apos;">

Is there a way to get the whole content of the configuration (preferable, in one message), like it is done in IOS with "no netconf max-message"?

-Alex.