I am runnning CW2000 4th Edition (RME 3.3) I'm unable to get Netconfig to run a job. The job I'm trying to run is to add a banner (MOTD) to a Cisco switch (IOS). I select immediate excution and hit finish. At this point the job browser appears and shows that the job is scheduled. In the Run Status column, I see the status change from "Missed Start" to "Start Failed". There is no other detail.
I found some troubleshooting info on netconfig on CCO but it does not address this problem. Any suggestions?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...