Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NetFlow and Cat4500E

Hi,

Does anybody know which flows can be monitored in a Cat4500E with SUP7-E or SUP7L-E? Can I monitor every flow in the switch (e.g. flows between two ports on WS-X4648-RJ45-E card) or can I monitor only flows that pass the uplink ports integrated on the Supervisor Engine?

I’ve found something for a Cat3560-X and 3750-x (see below), but I can’t find any similar information for Cat4500E.

Q. Can I monitor every flow in my switch using the Service Module?

A. All flows that pass the uplink ports are supported. Flows that do not traverse the uplinks like the flows between two access ports on the same switch or switch stack are not supported at FCS.

Thanks for your help.

391
Views
0
Helpful
0
Replies
CreatePlease to create content