My customer wants to deploy 3600 routers at a number of locations, with async and X21 connection to x25 networks. They want to use XOT to transport between the 3600s. There will be 7206 routers at the core, which will route between the 360's, and also have Netflow enabled.
My problem is that they want ot collect billing information on an x.121 address pair basis. I believe XOT will use spearate port numbers for each SVC, so the information should be gathered by Netflow, but I don't see any way to tie that back to the X.121 addresses. Does anyone have any comments/suggestions?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...