Net 10.2.1.0< --cisco 801(22.214.171.124) <-----ISDN <----cisco 700 (126.96.36.199) <-----> 10.3.1.0
I have connected the two cisco routers, cisco 700 as remote site and cisco 801 as central site, with an ISDN line.Now the connection between the routers is OK. But I can not do telnet or FTP from any PC of any network and I don't know what is wrong.
There are a few odd thing in 801 config. Please try the following:
no ip route 0.0.0.0 0.0.0.0 eth0 I do not see the need for this route.
add the following route:
ip route 10.3.1.0 255.255.255.0 188.8.131.52
As far as I can see this will do the job but I would also advise you to remove the RIP routing process from both boxes. Otherwise you run the risk of the ISDN line being connected 24 hours per day.
On the 801:
no router rip
Remove the dialer map xx broadcast line and replace it with the same mapping, without the broadcast statement. To achieve this use the no dialer map command using your old line and then reenter the same line without the broadcast keyword as follows:
no dialer map xxxx broadcast
dialer map xxxx
On the 700 series it looks to me as if you have used config-maker. You should run this again to remove the rip routing The required static route is already there.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...