I have 8 2950 Switches which are divided into 13 VLANs.
Let say vlan2 has 10 ports. PC1 connects to Port1 until PC10 connects to Port10. I want to apply the Access-list to VLAN2, meaning that I allow only 10 IP addresses of every PCs that connect to VLAN2 Port, but if another PCs that have different IP address. The Access-list will drop and can not access or connect to the ports that connect to vlan2. In this case, how to apply the access-list?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...