Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Network Slow transfer file

I am from Indonesia I have problem in my network after I install Switch Catalys 2900 and Catalyst 2900xp. My server and workstation are macintosh.

Question :

Why this happen ?, some of my computer 100BT Dupplex:Full some of them 10BT Dupplex : half,.

I turn off the spanning tree because if it on the network will down and loss connection from the Appleshare file server.

Thankyou and please .

6 REPLIES
Hall of Fame Super Silver

Re: Network Slow transfer file

I ran into the same issue and what we did was enable portfast. I still left spanning tree enabled. Hope this helps.

-Scott
*** Please rate helpful posts ***
New Member

Re: Network Slow transfer file

I did port fast enable but no for spanning tree, if I turn on (enable) spanning tree old apple computer ie: LC III/PowerPC 6200 some 6400 will loss connection from the Appleshare file server.

Thanks

New Member

Re: Network Slow transfer file

You should hardcode the Duplex and Speed on all server, router and uplink ports to other switches. You may find it necessary to just set the duplex and speed on every port and hardcode it in the OS as well. Can you hardcode the duplex and speed on Macs?

Regards,

jk, CCNP

New Member

Re: Network Slow transfer file

Could you please give more information how I do it to hardcode the dupplex and speed om mac ?

Cisco Employee

Re: Network Slow transfer file

Here is a link that should be helpful in troubleshooting the problem:

www.cisco.com/warp/customer/473/46.html

New Member

Re: Network Slow transfer file

yes I did hard code each port , 100BT half Dupplex computer to same speed at the switch port, full dupplex, 10BT, etc.

But my network still has problem, slow when I transfer file.

Thankyou

284
Views
0
Helpful
6
Replies