Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Network Speed

Here is a setup. Wondering what kind of speed I should see end to end (estimate).

P4 2.4 Server-100MB>>2950-100MB>>converto to fiber>>Telco 2950-100MB>>2691 Router-100MB>>2924-100MB>>Workstation-100MB

I'm only getting about 1MB sec.. Should it be more? I think so, but what do you think?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Network Speed

This sounds like a duplex mismatch. Make sure all speed and duplex settings are set the same. I would hard code the speed and duplex if at all possible.

Cheers!

Burleyman

2 REPLIES
Bronze

Re: Network Speed

It should certainly be more. Have you checked to make sure that all server/switch ports in your charge are running at 100Mbit/full-duplex? What are you doing to test the bandwidth? Have you tried a program specifically meant to test bandwidth such as TTCP?

Re: Network Speed

This sounds like a duplex mismatch. Make sure all speed and duplex settings are set the same. I would hard code the speed and duplex if at all possible.

Cheers!

Burleyman

217
Views
0
Helpful
2
Replies
CreatePlease to create content