I have a networking scenario where two offices will be connected with a private line. Each office will need to configure their own router and integrate into their existing network. The ISP informed me to configure the serial connection between the routers with /30 ip addreses.
I am unsure of how to properly configure the ip addresses, interfaces and networks on the routers. Could you please review the following and see if I am on the right track? As I am fairly new to routing configuration I thank you for your assistance.
Network 1 - Office 1
Contains Router A - 2 interfaces e0, s0
Host Server A on Network 1 - Dual Nics,
Nic 1 - connects to inside interface of network 1
Nic 2 - connects to switch, switch connects to Router 1 (e0)
Serial Interface s0 - will connect to s0 Router B in Office 2
Network 2 - Office 2
Contains Router B - 2 interfaces e0, s0
Ethernet interface e0 will connect to existing network
Serial Interface s0 - will connect to s0 Router A in Office 1
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.