Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

New 48 port blade in Cat4503

It's my understanding that the 4503 should recognize the new switch blade without configuration, is this correct?

Thanks,

Andy

4 REPLIES

Re: New 48 port blade in Cat4503

Hi Andy,

You are correct, it will recongnize it as long as it has the minimum required IOS to support the module.

Please Check the link below for minimum and recomended cisco IOS software.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/ol_5184.htm#wp16938

HTH, Please rate if it does.

-amit singh

New Member

Re: New 48 port blade in Cat4503

Apparently the 4503 is running CatOS judging from this output;

2nd-sw01> (enable) sho version

WS-C4503 Software, Version NmpSW: 7.4(2)

Copyright (c) 1995-2002 by Cisco Systems, Inc.

NMP S/W compiled on Oct 8 2002, 18:12:59

GSP S/W compiled on Oct 08 2002, 15:54:51

System Bootstrap Version: 5.4(1)

Do I need to move to a Cisco IOS?

Thanks,

Andy

Purple

Re: New 48 port blade in Cat4503

Whats the card number you are installing ?

New Member

Re: New 48 port blade in Cat4503

The card number is WS-X4548-GB-RJ45

174
Views
3
Helpful
4
Replies