03-08-2004 12:18 PM - edited 03-02-2019 02:07 PM
Okay, so I need to be able to have a device plugged into my 4506 that will need to be referenced from two seperate IP addresses. I was led to believe that I could simply sub-interface this port and be done with it. However, the basic feature set doesn't support this. Anyone have any ideas on this? Is this even possible? If I can't do this - can I do it any other way within my 4506? I'm running Basic Layer3 12.1(20) by the way.
03-08-2004 08:08 PM
hi
I think There is no option assiginig to IP address..
if u want to assign single IP address pls go trgh this command
set int sc0 5 x.x.x.x 255.255.255.0.
bye
sat
03-08-2004 08:21 PM
hi
In earlier command i have given 5 pls ignore that
I think There is no option assiginig to IP address..
if u want to assign single IP address pls go trgh this command
set int sc0 x.x.x.x 255.255.255.0.
bye
sat
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: