New Catalyst 4506

[admin_2]

Okay, so I need to be able to have a device plugged into my 4506 that will need to be referenced from two seperate IP addresses. I was led to believe that I could simply sub-interface this port and be done with it. However, the basic feature set doesn't support this. Anyone have any ideas on this? Is this even possible? If I can't do this - can I do it any other way within my 4506? I'm running Basic Layer3 12.1(20) by the way.

[sateeshk]

hi

I think There is no option assiginig to IP address..

if u want to assign single IP address pls go trgh this command

set int sc0 5 x.x.x.x 255.255.255.0.

bye

sat

[sateeshk]

hi

In earlier command i have given 5 pls ignore that

I think There is no option assiginig to IP address..

if u want to assign single IP address pls go trgh this command

set int sc0 x.x.x.x 255.255.255.0.

bye

sat