Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

New Code (7.6.1) on Cat 4006 & Inline Power Problem now with AP 350

Upgraded code on 2 different 4006 switches w /Sup II's from 6.4.1 to 7.6.1. Problem now is on both switches my AP 350's port keep going down (ran fine before the upgrade) with the error - %SYS-3-PORT_NOPOWERAVAIL

I feel that the new code lowered the power output per port and it is too low for the AP 350.

Any thoughts on this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: New Code (7.6.1) on Cat 4006 & Inline Power Problem now with

It's actually a bug in AP IOS.

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCea41998

Try disabling CDP as a workaround

2 REPLIES
Cisco Employee

Re: New Code (7.6.1) on Cat 4006 & Inline Power Problem now with

It's actually a bug in AP IOS.

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCea41998

Try disabling CDP as a workaround

New Member

Re: New Code (7.6.1) on Cat 4006 & Inline Power Problem now with

Thanks that was the problem...

104
Views
0
Helpful
2
Replies
CreatePlease to create content