Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Newbie needs help forcing ISDN disconnect

Hi. We have two 801 routers connecting offices over isdn. Thanks to a deal with the telecom company, we can get very cheap rate calls for anything up to one hour's duration. So what I want the routers to do is disconnect just before the hour is up. Normal DDR operation will then bring the line up again until the next hour, etc.

Is this possible in the software? Multiple time-ranges? If not, I presume some kind of scripted telnet session scheduled from a workstation could issue the ISDN disconnect command?

Any thoughts are most welcome.

Thanks

Ed

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Newbie needs help forcing ISDN disconnect

Under the BRI add the "timeout absolute xxx" where xxx is in minutes.

Thanks, Mak.

2 REPLIES
Silver

Re: Newbie needs help forcing ISDN disconnect

Under the BRI add the "timeout absolute xxx" where xxx is in minutes.

Thanks, Mak.

New Member

Re: Newbie needs help forcing ISDN disconnect

Mak,

I just realised that I had not replied to your post. Thanks for the info - it was exactly what I was looking for. I am using dialer profiles and so have applied it to that particular dialer interface. Coupled with quite a long idle-timeout value, the call disconnects on the button every time!

Once again, thanks

Ed

95
Views
0
Helpful
2
Replies
This widget could not be displayed.