I'm trying to understand the configs on a 6500 switch. I have a 6509NEBS with dual sup2 + MSFC + PFC. I understand that there is a set based config/software and IOS based config/software. If I telnet into the SC0 port, which config will I see? From there, how do I get to the other? I'm more used to the 5500 stuff where I would enter SESSION 2 to get to the RSM in slot 2, for example.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...