08-09-2002 06:01 AM - edited 03-02-2019 12:34 AM
Hi I'm new to this field & have been given an opportunity to configure a Cat4003 with routing module (sprvsr I-WS-X4012, rtng - WS-X4232-L3). There was no manual so I have been reading what I could find on Cisco's site & now am confused. I have tried the basic configs I found on Cisco's site but haven't gotten anywhere other then being able to telnet into the Supervisor's Module or the Routing Module. Could anyone tell me the basic steps to setup connectivity on 1 of the 10/100 ethernet ports of the router?
Thanks alot.
08-09-2002 06:11 AM
The 32 10/100 ports are all switchports and by default in vlan 1. If you believe you have some configuration on them, you can roll back to default by doing a "clear config
http://www.cisco.com/warp/public/473/8.html
Configure the "set port host x/y" if you are connecting end devices to the 10/100 ports
You can find documentation on CCO at
http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/rel6_3/index.htm
08-09-2002 06:32 AM
Thanks alot I'll check it out.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide