Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Newby with cat4003

Hi I'm new to this field & have been given an opportunity to configure a Cat4003 with routing module (sprvsr I-WS-X4012, rtng - WS-X4232-L3). There was no manual so I have been reading what I could find on Cisco's site & now am confused. I have tried the basic configs I found on Cisco's site but haven't gotten anywhere other then being able to telnet into the Supervisor's Module or the Routing Module. Could anyone tell me the basic steps to setup connectivity on 1 of the 10/100 ethernet ports of the router?

Thanks alot.

2 REPLIES
Cisco Employee

Re: Newby with cat4003

The 32 10/100 ports are all switchports and by default in vlan 1. If you believe you have some configuration on them, you can roll back to default by doing a "clear config ". Assign an IP address to sc0 interface of the switch for management purpose

http://www.cisco.com/warp/public/473/8.html

Configure the "set port host x/y" if you are connecting end devices to the 10/100 ports

You can find documentation on CCO at

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/rel6_3/index.htm

http://www.cisco.com/warp/public/473/

New Member

Re: Newby with cat4003

Thanks alot I'll check it out.

69
Views
0
Helpful
2
Replies