Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

next-hop-based rate-limiting

Hello,

is it possible to rate-limit traffic on next-hop value? Something like to:

int ATM1/0.150 point-to-point

ip address 192.168.0.1 255.255.255.252

pvc 0/150

[ ... ]

!

ip route 192.168.1.1 255.255.255.255 192.168.0.2

ip route 192.168.1.2 255.255.255.255 192.168.0.2

From 192.168.0.2 I receive (through BGP) announces of some networks, with different next-hops for different networks and need to rate-limit traffic, which flows through 192.168.1.1 and 192.168.1.2. Can anybody give me clues how to do this?

Thank you.

2 REPLIES
Silver

Re: next-hop-based rate-limiting

Use Rate-limits by access-lists.

Community Member

Re: next-hop-based rate-limiting

access-list doesn't rely on next-hop attribute

it allows

Router(config)#access-list 100 permit ip any any ?

dscp Match packets with given dscp value

fragments Check non-initial fragments

log Log matches against this entry

log-input Log matches against this entry, including input interface

precedence Match packets with given precedence value

time-range Specify a time-range

tos Match packets with given TOS value

89
Views
0
Helpful
2
Replies
CreatePlease to create content