Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

nGenius does not recognize Cat-2980G

I am running nGenious version 1.4 and attempting to add a Cat-2980G switch. I get the error message that the RTM does not recognize that device type. Does that mean the RTM can't monitor the Cat-2980G's?

Thanks.

1 REPLY
Blue

Re: nGenius does not recognize Cat-2980G

2980G is listed as supported 'Table 2: Cisco Catalyst Switches Supported by RTM': http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/fam_prod/netscout/rel_1_4/7814182.htm#xtocid14

Make sure that when you're adding this switch in RTM 1.4:

- Select the CAT2980G from the Select Switch Type pull-down and not use Automatic

- SNMP and RMON is enabled

- SP7 patch from CCO for RTM 1.4 is installed.

89
Views
0
Helpful
1
Replies