Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NM-24DM and PRI

We have a 3745 with 1 x VWIC-2MFT-T1, both are connected to the PSTN via PRI in voice mode (mgcp gateway to call manager). We also have a NM-24DM module in the router. Currently the contollers/serials interface are set for time slots 1-24, with one D chnl as isdn incoming mode voice. Is there a way to split or support modem calls for remote access via the same PRI's for certain numbers on the DID block to the PRI. Thx.

2 REPLIES
Bronze

Re: NM-24DM and PRI

Bronze

Re: NM-24DM and PRI

I'm afraid not:

"The Multi-Flex Trunk, with or without High Density Voice Nework Module, can not terminate modem connection on the router"

source: http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml

106
Views
0
Helpful
2
Replies