". By Advanced Research Projects Agency (ARPA) ARP, you mean "Ethernet interfaces" and, by default, ARP ARPA is set with no arp snap. This means that ARPA style ARPs are sent, but both ARPA and Subnetwork Access Protocol (SNAP) are answered. By setting no arp arpa, ARP requests are disabled, although null entries are created for every station to which an ARP request is attempted. You can enable SNAP alone, ARPA alone (the default), both SNAP and ARPA together (send two ARPs every time), or neither SNAP nor ARPA (which is what happens if you set no arp arpa without setting up any other ARP). "
From the above description it appears that the command only disables, outbound arpa arp requests, not inbound.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...