Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

no clocking from telco on T-1 - how to config CSU?

I've never had to provide clocking from our CSU/DSU's. I just need to verify that one side is set to INTERNAL and the other is set to NETWORK.

Thanks!

1 REPLY
New Member

Re: no clocking from telco on T-1 - how to config CSU?

That is correct. And by the way, I usually specify that telco provide timing when I place the order for a circuit. They can't always just switch it on and off once the circuit has been established. It must go through a DACS for telco to turn timing on (usually done by the LEC - not the IXC).

Regards.

84
Views
0
Helpful
1
Replies
CreatePlease to create content