I have got a problem getting a multi vlan port to work properly on a C2924XL (IOS 12.0(5)XU). I often experience loss of connectivity between the server ONE plugged into that multi vlan port (#1) and other servers plugged into the single vlan ports (so far all on vlan 1, nothing is plugged into the vlan 2 ports yet). The switch is not connected to other switches, no trunking is enabled.
Perhaps someone is able to help.
The layout is such:
Port#1 is set up for vlan 1 and 2, all other ports are set up for vlan 1 or 2 only.
switchport multi vlan 1,2
switchport mode multi
vlan 1 and 2 are setup:
VLAN ISL Id: 1
Media Type: Ethernet
VLAN 802.10 Id: 100001
Translational Bridged VLAN: 1002
Translational Bridged VLAN: 1003
VLAN ISL Id: 2
Media Type: Ethernet
VLAN 802.10 Id: 100002
When I boot the servers more often than not the server ONE is only able to connect(ping/telnet) to the switch, not to the other servers. At the same time the switch is able to ping all servers, including ONE. When I plug the server ONE into any
other port I have instant connectivity to the other servers.
Re: no connectivity from multi vlan port on C2924XL
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.