Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No EIGRP neighbor on Layer 3 port

After "switchport" was removed on the 6509 Gig 1/1 port, I then assign an IP address to it as well as the other end of the cable which is an 2821 router to use it as a Layer 3 ports. I can Ping across the interfaces but they can't establish EIGRP neighbor. Any ideas what I am doing wrong?

3 REPLIES
Hall of Fame Super Bronze

Re: No EIGRP neighbor on Layer 3 port

Is the new IP address included in the eigrp process ?

Can we see the show ip eigrp int output from both devices ?

Purple

Re: No EIGRP neighbor on Layer 3 port

Did you add your network statement for the link under the eigrp process.

New Member

Re: No EIGRP neighbor on Layer 3 port

Thanks for quick responds from you and EdisonOrtiz that point me to the right direction .

I had a bad mask in EIGRP statement, things are looking great now.

137
Views
0
Helpful
3
Replies