We use a few routers with the switch module installed. We need to have the command "No IP IGMP Snooping" to stay in the router after a reboot, however, we always have to re-enter the command. After doing this for quite some time we're considering purchasing the newer POE switch modules for our routers. With this purchase will we be able to enter the command and keep it in the config after a reboot.
For igmp-snooping to operate properly, you need to have IGMP-Querier on the LAN, which can be provided by the Router with PIM enabled interface, or by the L2 switch itself with IGMP-Querier feature available in the new code versions.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.