Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

No output for show running-config

12.0(5.30WC1

3548XL switch

When you do a show run, it doesn't display any output. When you do a sh config, it shows. You make a change to config, and do a wr mem, the change can be seen in sho config. But show run gives no output.

I have seen some bugs which says in low memory condition this problem could occur. This switch however doesn't have a high mem utilization.

2 REPLIES
Silver

Re: No output for show running-config

Irrespective of mem utilization, you need to have atleast 8MB of memory. Apart from bugs on less memory, I guess there should be no other problem.

Re: No output for show running-config

Hi,

is there any difference using sh run and write term commands?

From console or Telnet session?

Have you reloaded the switch?

Regards,

Milan

304
Views
0
Helpful
2
Replies
CreatePlease to create content