Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

no PAgP logging on cat 4006 after sofware upgrade to 7.3

After upgrading software, "show logging" no longer lists the pagp facility and there are no more "%PAGP-5-PORTFROMSTP:Port 1/3 left bridge port 1/3" messages in the log...

2 REPLIES
New Member

Re: no PAgP logging on cat 4006 after sofware upgrade to 7.3

PAgP was available in versions prior to 7.1(1). In versions 7.1(1) and above PAgP is replaced with IEEE 802.3ad Link Aggregation Control Protocol (LACP).

Go to the following link for more information:

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_example09186a0080094470.shtml

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_guide_chapter09186a00800e46f6.html#23603

Cisco Employee

Re: no PAgP logging on cat 4006 after sofware upgrade to 7.3

Logging facility PAGP is replaced with ETHC beginning 7.x

108
Views
0
Helpful
2
Replies