Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

VIP Purple

No physical hardware support

Hello colleagues,

I just obtained a 2610. I upgraded the flash memory from 8 to 16. When I try to add the group-range command to the Group-Async1 interface, I get a message telling me no physical hardware support. Does anybody know what that means ? I am not sure why that happens, since I didn´t change the hardware, just the memory.

Thanks for your help in advance.

Regards,

Georg

1 REPLY

Re: No physical hardware support

Do you have any Async net modules installed? If you do make sure the router is recognizing them (show diag). You may want to try to reseat them. You may need to change your version of code if they are not being recognized if this new.

Under 'show run' do you have async line interfaces (ie: line 33 48, etc)?

If you don't have any async interfaces you won't be able to group them together.

925
Views
0
Helpful
1
Replies