No response from Console session at intial configuration dialog
After a 2501 router had been sitting for a while I powered up the router I got the question on the intial configuration dialog where it asked
"Do want to enter auto config mode " yes/no
and then after that the keyboard does not respond and I can go no further. The console cable , computer and connetion works fine on another router. Any ideas of suggestions? I am running 12.1 (10) on the router .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.