I have not received any results in my DFM Fault History since Feb 4. All processes appear to be running normally, but in the Adminstration Console, I am being prompted to enter a domain to attach to. But nothing I put in the Domain box works. I always receive a message that DFM is not registered with the broker.
This is the message I receive when using Fault History - "No device found for your selected filters. Please change filters."
Using CiscoWorks 2000 with Device Fault Manager 1.2 on a Sun box.
if DFM is not connected to a domain or cannot connect to the Broker this usually happens after changeing the hostname of the management server. Try to add your servers IP and port 9002 in the following form:
This can also be a problem if the host from which you launch your management is not able to resolve the servers name. If this is the fact you can work around by adding it in your hosts file.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...