I'm using a Catalyst 6509 with a Sup2 engine. The Sup card has a PCMCIA card that's accessible when I'm in the switch mode. However, when I go to rommon in Router mode, I can see bootflash: but not the slot0:
I'm using CATos. The image in bootflash: is corrupted and I get dummped into rommon. I'm trying to somehow get a image into bootflash:. I know it can be done through console connection using xmodem command, but it take a long time.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...