Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

not able to convert 1131 ap LWAPP to autonomous

Hi,

I have issue for converting lwap to autonomous for lap1131 model.

According to cisco document, i have followed the below procedure :

I  have formatted the flash as well as followed the same procedure


format flash:

reset

  1. Then type in:

set IP-ADDR 10.0.0.1
set DEFAULT_ROUTER 10.0.0.2 (yout laptop/PC IP address)
set NETMASK 255.255.255.0
tftp_init
reset.

but when i give the below command , i am not able to get any response from ap :

tar -xtract tftp://10.0.0.5/ c1240-rcvk9w8-tar.124-10b.JA3.tar flash:

what to do , i am really stuck with that ...

I have attached the details when i could upload the ios which was not valid.

I have downloaded the ios from cisco site .... below the name of file with size 5450.00 KB

file name : ----- c1130-k9w7-tar.124-10b.JDA3.tar

what should i do next ?

Please suggest me for the same.

I am really stuck up with this ..........

It would be appreciatve for getting proper answer.

I am not able to find the root cause of this issue ... whether it is IOS issue or whether it is ap issue ?

please guide me for the same.

412
Views
0
Helpful
0
Replies
CreatePlease to create content