Hi All,
Can anybody help me with the cause of the below error ?
ds-22(config-vlan)#int vlan 3780
ds-22(config-if)#no vlan 3780
Cannot delete vlan 3780 as it is configured as bridge domain vlan
I configured the following L2 VFI commands on both Primary and Secondary Distribution Switches (7600 Series)
ds-22(config)#l2 vfi VFI-13000 manual
ds-22(config-vfi)#vpn id 13000
ds-22(config-vfi)#neighbor a.b.c.d encapsulation mpls
However , the show vfi command on the secondary DS shows the vlan as a Bridge-Domain attachement circuit, while the Primary DS shows it as local attachement circuit.
Primary DS VFI
===============
ds-25#sh vfi name VFI-13000
Load for five secs: 2%/0%; one minute: 3%; five minutes: 3%
Time source is NTP, 09:18:32.204 MEST Mon Oct 21 2013
Legend: RT=Route-target, S=Split-horizon, Y=Yes, N=No
VFI name: VFI-13000, state: down, type: multipoint
VPN ID: 13000
Local attachment circuits:
Vlan3780
Neighbors connected via pseudowires:
Peer Address VC ID S
a.b.c.22 13000 Y
Secondary DS VFI
===============
ds-22#sh vfi name VFI-13000
Load for five secs: 3%/1%; one minute: 6%; five minutes: 5%
Time source is NTP, 09:16:16.213 MEST Mon Oct 21 2013
Legend: RT=Route-target, S=Split-horizon, Y=Yes, N=No
VFI name: VFI-13000, state: down, type: multipoint, signaling: LDP
VPN ID: 13000
Bridge-Domain 3780 attachment circuits:
Vlan3780
Neighbors connected via pseudowires:
Peer Address VC ID S
a.b.c.22 13000 Y
Secondary DS Vlan
===============
interface Vlan3780
no ip address
no ip igmp snooping
shutdown
no ipv6 mld snooping
xconnect vfi VFI-13000
end
Primary DS Vlan
===============
interface Vlan3780
no ip address
no ip igmp snooping
shutdown
no ipv6 mld snooping
xconnect vfi VFI-13000
end
Why is the VFI configuration different on the Secondary DS ?
Is that the cause for this error ?
Pelase help.