Hi all,
During troubleshooting of Cat 4506 switch with Access gateway module installed in it.I had logged in the AGM via session command from the Cat 4506. Once I had logged in the AGM (IOS ver 12.105 YF) I had issued a write erase and reload for the AGM. After the AGM had booted up. I was unable to login into the AGM via Cat 4506 switch( using session command) but I was able to log via console.
The AGM is installed in module 2 of cat 4506 switch So when I use the session command (session <module number>) to access the AGM from switch. I get the following message on the console window
Trying Intglinecard - 2
Session: Unable to tunnel to Intglinecard - 2 (57).
Can some one help me on this issue. Do I need to enable few commands on switch so that I can have the session login back ?
Thanks and regards,
Pradeep