Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not able to use NetConfig to config. device

Hi,

I encounter the following error msg when using NetConfig to configure Cat Switch (model: WS-C2924M-XL, c2900XL-c3h2s-mz.120-5.WC3b.bin)

Error Messages as follows:

"Device was successfully downloaded, Sync Archive failed

Device manage:No Rollback Change Required

---Update Result: Partially Successful

PGN_NM=Configuration Archive:6775:TYPE=unassigned message type:Failed to get running config. for device...

"

From RME Drawer, Administration, Conf. Mgmt, Archieve Status. There is not reported for this device?

6 REPLIES
Blue

Re: Not able to use NetConfig to config. device

RME version?

New Member

Re: Not able to use NetConfig to config. device

RME3.4, IDU Version 4-0

Blue

Re: Not able to use NetConfig to config. device

Increasing the SNMP timeout in RME is one thing to try and then re-try again. Is this device setup with the standard > and # prompts for telnet/enable?

New Member

Re: Not able to use NetConfig to config. device

I have set the SNMP timeout to 120 sec and still getting the same error.

Also, I notice that my running-config has been changed on the device, for example, I want to change my banner motd on the device, after executing the Netconf with my own customize MOTD, the old banner gets removed and the new MOTD is not being config. on the device. Why is this so?

P.S. the device prompts is the standard > & #.

Blue

Re: Not able to use NetConfig to config. device

This may require some detailed troubleshooting. TAC can help you with that.

eap
New Member

Re: Not able to use NetConfig to config. device

Did you ever get a solution to this? I am having the same problem.

Thanks,

Paula

178
Views
0
Helpful
6
Replies
CreatePlease to create content