Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NPE-300 MEMORY ERROR

I am receiving the following error on a 7206VXR with a NPE-300 installed:

ROM: DIMM 0 is not the factory fixed/supported 32MB DIMM!

ROM: Please replace DIMM 0 with the original 32MB DIMM.

Can I just order a new MEM-SD-NPE-32MB for this slot, or does it take special memory? Thanks for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: NPE-300 MEMORY ERROR

The error you are seeing is because the dimm in slot 0 has been replaced. If the original dimm is not in that slot and if you still have it then place it back in that slot. If you do not have it then the NPE will have to be replaced.

1 REPLY
Silver

Re: NPE-300 MEMORY ERROR

The error you are seeing is because the dimm in slot 0 has been replaced. If the original dimm is not in that slot and if you still have it then place it back in that slot. If you do not have it then the NPE will have to be replaced.

294
Views
0
Helpful
1
Replies
CreatePlease to create content